Service Hotline
15957498688

Products informationcurrent location:homeProducts information

How to Install a Cat.5/5e cable

     1. Material

      (1) Prepare UTP Cat.5/5e twisted pair cable less than 100m

 (2) Punching the twisted pair into RJ45 8 pin Plugs so that it can insert into the connector

2. Tool

      (1) RJ45 punching tool/stripper tool

      (2) Cable Tester

 

     3. Port standard

   International standard EIA/TIA 568A/568B are both compatible

   Normally there are 2 types of wiring: direct line and crossing line

  (1)Direct line: based on T568B standard, and punching cable into RJ45 plug

      (2)Crossing line: cable one side with T568B, another side with T568A

 

Actually, the direct line can use other wiring method, just confirm both sides with the   same color wiring sequence. However such wiring will not be in accordance with         international standard, and slow the transmitting speed. It’s better to punching based on international standard

 

      4.  Instructions

     (1)Prepare the suitable twisted pair cable length

     (2)Strip 1.5mm length from the jacket, don’t injury the conductors, separate the 4             pairs and make it 8 wires in right sequence and then cut perfectly with the tool

     (3) Put the 8 wires into the plug 8 pins. Make sure of the wire contact with the                  bottom of the plug

  (4)Use crimping tool and press the wire tightly into the plug

    (5) Punching the other side in the same way. If for crossing line, make sure of the     

        different wiring sequence

    (6)Test the cable by RJ45 cable tester in case of any disconnection

 


 

 


feedback

Sweep access to the mobile